Expert answers
Palych!:
With this age of pipes, only mechanically is better. DHW pipes have a service life of 15 years. HVS - longer. Blockages blockages strife. or deposits along the entire length, or alluvial dirt. She is at the corners and corners of pipes, at welds and joints - where she can catch on. Ideally, it is better to clean the alluvial dirt by back blowing with a hydro-air blow in the direction from the mixer to the inlet valve - if you can organize the process of blowing and draining the dirt, you should not drive to the neighbors)))). a cable for a drill is also an option, but it does not work everywhere.
Vasya schneider:
Experience, that is, but bad - the pipes were more years old than me, I filled in the pipe cleaning fluid and they flowed, only not so long ago I paid my neighbors for the flood
Victor Smirnov:
Cold water pipes become clogged, on the contrary, they become thinner in hot water. There are a lot of salts in cold water, so they are deposited on the walls. You can try it purely mechanically, with a rigid steel wire, but you can’t get through it at the corners (and you also need to remove the taps). Exit, just a replacement. If you decide, then change to metalloplastik or polypropylene.
Vasina Ya.:
You can ask plumbers. Under pressure, drive out all blockage. Think so..)
Joker Benya:
try blowing it out with a compressor
Grandfather Au:
I cleaned it well with a cable from the speedometer, holding it in a hand drill, now I put metal-plastic
Vitalban1:
While you're cleaning, go to the well faster.
natasha kovylina:
Cable, it is sold in plumbing stores.
Svetlanka:
Tiret buy
Yaroslav:
plumbing cable
Avk:
Many concentrated gels are now available for cleaning pipes, For example, Tiret, Mole, etc. The instructions for them are simple and short: pour into the sink, pause, rinse.
Sobchenok:
vantus and all sorts of corrosive pipe cleaners.
Anna Chekalina:
If you're talking about draining, you can buy pipe cleaning liquid/powder from the hardware store. Come there, ask - you will definitely be prompted. And then follow the instructions. Just read the instructions BEFORE using
Beaver:
5% HCl solution
Konstantin:
there is no water supply, it only needs to be changed ... but the sewer can be, it is enough to disassemble it!
Andrey Volkov:
It is necessary to clean the filters or remove the mixer - and on the duct
Alexander Novozhilov:
Konstantin is right, water pipes are not cleaned, but at least 30 years must pass before the pipe needs to be replaced, and it is not clear - if the pipe is used constantly, then an oxide layer forms on the inside of the pipe, which protects the pipe from further corrosion. I dismantled heating systems built in the 50s of the last century, so the pipes are in excellent condition.
Alexander Greshnev:
Water supply steel pipe can be easily cleaned with a drill and steel wire. You fix the wire in the drill chuck and .... went. The valve on the pipe must of course be closed. You can determine the diameter, length of the wire and the power of the drill, I think, by yourself. I cleaned it once, open the valve ... And so on until complete cleaning. I wish you success.
aviator:
If the water pipe is veiled, disconnect it and rinse it under running hot water. If this is not possible, use a plumbing cable. But it happens that the cable does not help. Then it is better to resort to the help of a tool called the "mole". A good tool. Pour into the pipe and wait for some time indicated in the instructions, then rinse thoroughly with water. Because it contains an acid.
VSOP:
No plumbing. But you can use a plastic drain, buy a special Corrugated Corrugated Cord, put it in the drain and turn it, moving it back and forth. Made in Italy. It costs 600 rubles in any plumbing store or supermarket.
What and how to clean water pipes
They also accumulate inside metal pipes due to the roughness of their inner surfaces. All this leads to a decrease in the pressure of water in the taps and the need to intervene in the water supply system.Therefore, in this article we will determine how to clean a water pipe from various materials.
Places of possible water clogging
There are places in the water supply system that are most susceptible to the threat of clogging:
It is recommended to replace faucets and faucets every 5-6 years.
- mesh filters located on the mixers. Clogged with small hard particles. Cleaning is done after unscrewing the nut on the spout of the mixer,
- water meters. Mesh filters are clogged and salts are partially deposited on the walls of metal adapters. The problem is solved by cleaning the filter or partial disassembly of the meter. You just need to be sure that the meter was the cause of the clogging,
- bends in the pipeline, especially if they go at an angle of 90 degrees. Due to the weakening of the water pressure in the places of bends, there is a narrowing of the gaps inside the pipes. This is a disease of steel structures.
Next, let's see how it is better to clean the water supply pipes if the water pressure has weakened, and manipulations with faucets and strainers have not led to anything.
Cleaning a water pipe with a cable
There are special plumbing cables made of elastic steel. With their help, you can radically solve the problem of blockage in metal pipes clogged with scale. The cable has a handle, by turning which you can clean inside the line. At the same time, the places of bends are easily passed by the cable due to its design.
- water is blocked in the pipeline,
- taps or faucets are unscrewed,
- a cable is inserted into a clogged pipe,
- turning the handle, advance the cable along the highway. In the process of movement, the cable destroys deposits on the inner walls of the conduit,
- periodically it is necessary to turn on the full pressure of water, which will wash out all the dirt from the pipes.
It should be noted that this method of cleaning is unacceptable for plastic pipes in which deposits do not form.
Cleaning the water pipe with the dismantling of the pipe
If cleaning with a cable did not work, then there is a more time-consuming way to restore normal water flow. To do this, you need to partially dismantle the pipes and clean the clogged areas.
Of course, it is very problematic to radically solve the problem in this way. Moreover, other sections of the pipes may subsequently become clogged. So it is better to replace them with new products.
How to clean the pipes in the bathroom or in the kitchen? Metal sections are connected by hollow threaded corners. Therefore, disassembly is carried out by twisting straight pipe sections from such corners using two gas wrenches. Disconnected pipes are cleaned with a strong pressure of hot water or by mechanical cleaning with a cable. After cleaning, the elements of the system are connected in the reverse order.
Chemical cleaning of water pipes
How to clean water pipes with chemicals? The agent is simply poured into the plumbing system. After a certain time, the system is flushed with a large amount of running water. The properties of the reagents that are used as chemical cleaning agents are such that they dissolve only deposits formed on the pipe walls. They do not affect metal, polypropylene, galvanized or metal-plastic.
Chemical cleaning is especially effective in private homes, since it is very difficult to let the reagent through the system in high-rise buildings.
How to clean plastic drain pipes?
The question of how to clean plastic pipes is the most relevant, because now plastic plumbing is very popular. Plastic pipes have a smooth inner surface that is not subject to corrosion. Therefore, such products rarely become clogged. If deposits do occur, it is exclusively in the drain system. Usually, fatty deposits and hair accumulate on the walls of the pipes.They gradually clog the passage of wastewater, which forces them to resort to their removal.
As measures for cleaning drain pipes, chemical or mechanical means can be used. Usually it is possible to do without dismantling the entire drain system. As already mentioned, the plumbing cable works well. Excellent results are obtained by the use of chemicals that are simply poured into the sink or into the bath. After a certain time, the system is flushed with water.
Reasons for the lack of water in the tap
A lot depends on:
- What is the condition of the pipeline?
- during what period of time pipes are operated without repair service;
- what material your pipes are made of (metal or plastic);
- if the mixers or valves are out of order.
Please note: In most cases, blockages are not found at all inside metal-plastic pipes. Options for cleaning pipes at home are determined by specific factors:
Options for cleaning pipes at home are determined by specific factors:
- the technical condition of the pipes (it is possible to dismantle the clogged section or the entire system);
- pipe location;
- your skills.