Thin soundproofing MaxForte SoundPRO
When the area of an apartment or room does not limit the choice of materials, and you can install sound insulation of any thickness, this is convenient. But what if you can't afford to spend precious inches of living space?
In this case, the innovative thin soundproofing material MaxForte SoundPRO will suit you. It has a thickness of only 12 mm, while in terms of its characteristics it is able to compete with sound insulation with a thickness of 5 and even 10 cm! MaxForte SoundPRO is the latest material designed specifically for soundproofing residential and industrial premises.
Thin soundproofing MaxForte SoundPRO
Specialists from the Research Institute of Building Physics and the Department of Acoustics of the Faculty of Physics of Moscow State University took part in the development of the material. In the manufacture of MaxForte SoundPRO, all the important points for the effective operation of the material were taken into account: the optimal density was selected (with a low density, the sound will pass through, if it is too high, along the “skeleton”), the length of the fibers, their thickness. The sound absorbing layer is calibrated and uniform throughout the area. The material is completely non-flammable. The composition does not contain harmful phenol-formaldehyde resins and any adhesives. Therefore, in addition to excellent soundproofing properties, MaxForte SoundPRO is safe for health.
MaxForte SoundPRO gives an increase in sound insulation from both air (loud TV, a crying child, screams of neighbors) and impact noise (noise from trampling, grinding furniture, falling objects). It can be used for soundproofing ceilings, walls and floors, which will give a significant increase of up to 64 dB!
Installation of thin noise insulation is very simple, and not only professionals can handle it, but anyone who has ever held a hammer drill and a screwdriver in their hand.
MaxForte SoundPRO is mounted on the wall using ordinary plastic dowel mushrooms, which can be purchased at any hardware store. It is hung on the wall using the butt-to-butt technology, after which it is covered with a layer of GVL (gypsum fiber sheet). All seams of the sheets must be glued with a special vibroacoustic non-hardening sealant. After the soundproofing is sewn up with a layer of GKL (gypsum plasterboard). The seams of the GVL and GKL sheets should be in a run, that is, they should not match.
MaxForte SoundPRO installation diagram
Visually about the installation of thin sound insulation MaxForte SoundPRO you can see in the video.
